4PCS For 2019-23 Jeep Gladiator JT Front+Rear Inner Fender Liners Steel Off-road

  
Installation Video Rear Inner Fenders Liners. Jeep Gladiator JT Utility style Rear Fender Liners Install from Wolfstorm Offroad (WASJT01G101-BX-R). Inner Fender Liners compatible with Jeep Gladiator JT & Unlimited 2019 2020 2021 2022 2023, 2 Door & 4 Door models. Surface Finish: Black Powder Coated Steel.

Installation-type: Direct bolt-on withno drilling required. Front Fender Liners Size: 38.2 x 12.8 x 20.9 inch.

Rear Fender Liners Size: 40.9 x 9.6 x 14.5 inch. Fits for 2019, 2020, 2021, 2022, 2023 Jeep Gladiator JT Unlimited 2-Door & 4-Door All Models. Why use Inner Fender Liners? HAWKLEY Fender liners are an indispensable accessory for your Wrangler, protecting the wheel wells from off-road elements such as sticks, gravel, mud, snow, sand and more. Acts as an all-around shield for the engine. At the same time, the smooth flat design is very easy to clean.

Just use the high-pressure washer gun to easily clean the sand on the surface. 1x Front Inner Fender Liners(Right & Left Sides).

1x Rear Inner Fender Liners(Right & Left Sides). 1 set of mounting hardware. DIY Your color - Re-Painted Exclusive Design. You can redesign your inner fenders by repainting to make it more exclusive to you and your car. Warm Tip: You have better install the inner fender liners on the car after the re-spray is completely dry. HAWKLEY JT Alloy Steel Inner Fender Liners. Prevent mud from splashing on the engine which causes rusting. Corrosion-resistant alloy steel construction, Full coverage Improved visuals. Trap excess heat, good for the increment of horsepower and efficiency. Allow the ventilation of engine bay to keep the engine run in good operation. Easy bolt-on install for front Inner fender liners, using factory holes. No cutting or drilling required. Assemble the scattered inner fender liners with screws, tighten all the screws with a hex wrench, and the nuts should be placed inside.

Put the assembled inner fender liner to the installation position. Adjust the position of the inner fender liner to the appropriate position, so that its screw hole can be aligned with the corresponding hole on the car, and then just tighten all the screws.